octodash 2.1.1 starts PLA print at 425 degree !

[3dattic]

Describe the bug
A clear and concise description of what the bug is.
using Prusa 3MKs
OctoPrint on Raspberry Pi 3B
Octodash 2.1.1
when starting the print from OctoDash the temp setting for PLA goes to 425 degrees. the prints stops with a Max Temp error. or a reset of printter and then when run again it works okay.
To Reproduce
Steps to reproduce the behavior:

1. Go to 'save gcode to OctoPrint '
2. Click on 'start print PLA'
3. Temp goes to 425 degrees

Expected behavior
A clear and concise description of what you expected to happen.

Screenshots
If applicable, add screenshots to help explain your problem.

General Information:

• Hardware Raspberry Pi 3b,
• OS Info Raspbian OctoPi
• OctoDash Version 2.1.1
• OctoPrint Version [1.4.2]

[UnchartedBull]

OctoDash doesn't change any of the existing GCode, neither does it set any temperature if you start a print. Have you started the print from the OctoPrint webinterface? Does the error appear there as well?