You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Hi,
right now the axis movement is limited to fixed values (1, 5, 10, 50... mm).
Is it possible to edit this values, for example when I level the bed, I like to lift the Z axis in small steps.
Or is this already possible?
best regards
The text was updated successfully, but these errors were encountered:
I assume you do not understand what I mean. I do not want do modify the Z height during printing. I just want to set the height in smaller steps, like 0.025, 0.05 and 0.1mm for leveling the bed.
As I see so far, Octodash only allows 1mm and higher height steps?
Hi,
right now the axis movement is limited to fixed values (1, 5, 10, 50... mm).
Is it possible to edit this values, for example when I level the bed, I like to lift the Z axis in small steps.
Or is this already possible?
best regards
The text was updated successfully, but these errors were encountered: