You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
What doesn't work?
When OctoDash try to remove my filament, it removes the entire filament very slowly (300mm/min or 5mm/sec). I set the Feedspeed to 20mm/s and the FeedspeedSlow to 5mm/s. I tried to use the values in mm/min but still the same.
I can't proceed with the filament change because my Octoprint disconnect my printer by TimeOut.
I check de Terminal via Octoprint and OctoDash send multiples "G1 E-100 F300" instead one "G1 E-700 F1200".
PS:
What did you already try?
I changed the settings using SSH and directly using Pi
General Information:
Hardware Raspberry Pi 3 B
OS Info: Raspbian Debian 10 buster / OctoPi 0.17.0
OctoDash Version 2.0.0
OctoPrint Version 1.4.0
Additional context
I don't use M600 command, and when I run a code manually to change my filament with the same speed, it done fast.
The text was updated successfully, but these errors were encountered:
Please check your OctoPrint Profile. You can define max speeds per axis there, which can't be overwritten by OctoDash AFAIK. Let me know if this works:
Please check your OctoPrint Profile. You can define max speeds per axis there, which can't be overwritten by OctoDash AFAIK. Let me know if this works:
What doesn't work?
When OctoDash try to remove my filament, it removes the entire filament very slowly (300mm/min or 5mm/sec). I set the Feedspeed to 20mm/s and the FeedspeedSlow to 5mm/s. I tried to use the values in mm/min but still the same.
I can't proceed with the filament change because my Octoprint disconnect my printer by TimeOut.
I check de Terminal via Octoprint and OctoDash send multiples "G1 E-100 F300" instead one "G1 E-700 F1200".
PS:
What did you already try?
I changed the settings using SSH and directly using Pi
General Information:
Additional context
I don't use M600 command, and when I run a code manually to change my filament with the same speed, it done fast.
The text was updated successfully, but these errors were encountered: