Skip to content

Latest commit

 

History

History
91 lines (72 loc) · 3.8 KB

Build_Image.md

File metadata and controls

91 lines (72 loc) · 3.8 KB
Raw

Ansible playbooks to build a CoachProxyOS Raspberry Pi image

The CoachProxy image build is automated using the Ansible system configuration tool. Installing and and configuring Ansible is outside the scope of these instructions.

Base Image Setup

Installing the CoachProxy software requires a network-accessible Raspberry Pi (hereafter referred to as RPi) running the Raspbian operating system. Installing Raspbian is outside the scope of this documentation, however a few links and tips are provided below:

  • At this time, the 2019-09-26-raspbian-buster-lite.img image is the latest version that has been tested with CoachProxy, though any version of Raspbian Buster should work. It can be downloaded at: raspbian_lite-2019-09-26.
  • Instructions for copying the Raspbian image onto an SD card are at: Installing Images.
  • Your local WiFi network SSID and passkey must be configured on the Raspbian image, and SSH enabled to allow remote login to the RPi. Instructions for these settings are at: Setting up a RPi Headless. You can optionally connect the RPi via an ethernet cable and skip the WiFi configuration, but must still enable SSH access via the above instructions.
  • After the base Raspbian image is installed and your WiFi settings and SSH are configured, insert the SD card into an RPi and power it on.

Once the RPi is connected to your network, determine its IP address by checking your router client list, and install your SSH authorized key. This will allow you (and Ansible) to connect to the RPi without a password. You'll need to enter the default Raspbian password to install the key:

ssh-copy-id -i ~/.ssh/id_rsa pi@<ip address>

Next, update the inventory/hosts.yml file in this repository with the RPi IP address so Ansible can connect and continue the configuration.

Lastly, update the roles/base_os/files/public_keys/root-coachproxy file with your public SSH key. This key will be installed into the root account on the RPi, enabling you to SSH into the device's root account if needed.

CoachProxyOS Ansible Playbook

Run the coachproxyos.yml playbook to perform the majority of the installation and configuration. The install will take 20-40 minutes and will download quite a bit of data over your Internet connection.

$ ansible-playbook coachproxyos.yml

Ansible playbook output

Note: the install changes the default editor from nano to vim. If you are not familiar with vim, you should delete the bottom code block (Set vim as default editor instead of nano) from the roles/base_os/tasks/main.yml file before running ansible-playbook.

Creating Reusable Image

The device is now ready to use. However, it's advisable to capture the completed image to a file, so it can be restored in the future rather than repeating all the above steps.

To do this, ssh into the RPi and issue a sudo shutdown now to shut it down. Move the SD card to another computer and use software on that computer to save the full SD card image to a file.

For example, to capture the SD card image on an Ubuntu Linux server, with the SD card mounted as disk sdd:

sudo umount /dev/sdd1 /dev/sdd2
sudo dd bs=4M if=/dev/sdd of=coachproxyos_1.0.img

After capturing the image, a utility like PiShrink can be used to shrink the image for use on smaller SD cards.