You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
The use of the variables ubulk and uouttot are currently a bit confusing.
The variable uouttot is calculated in the flow rate forcing and then (always? only with some switches?) overwritten and used by modboundary. It needs to be checked that this is done correctly and as intended.
The calculation in modstartup and use of the variable ubulk in modboundary should also be checked. ubulk is the volume averaged velocity (e.g. 2 m/s), and uouttot as calculated in the flow rate forcing masscorr is the outlet plane averaged velocity times the outlet area.
The text was updated successfully, but these errors were encountered:
The use of the variables
ubulk
anduouttot
are currently a bit confusing.The variable
uouttot
is calculated in the flow rate forcing and then (always? only with some switches?) overwritten and used bymodboundary
. It needs to be checked that this is done correctly and as intended.The calculation in
modstartup
and use of the variableubulk
inmodboundary
should also be checked.ubulk
is the volume averaged velocity (e.g. 2 m/s), anduouttot
as calculated in the flow rate forcingmasscorr
is the outlet plane averaged velocity times the outlet area.The text was updated successfully, but these errors were encountered: