GPS-Tracking-System

System Diagram

Circuit Schematic

Circuit Implementation

Our project consists of five main components:

1. TM4C123GH6PM microcontroller
2. RC1602E character LCD
3. Ublox NEO-6m GPS Module
4. HC-05 Bluetooth Module
5. Trajectory Plotter App

Pin Configuration

Bluetooth Module PINS	TM4C123 GPIO PINS
+5V	VBUS
GND	GND
TX	PE4(uart7_rx)
RX	PE5(uart7_tx)

GPS module PINS	TM4C123 GPIO PINS
VCC	VBUS
GND	GND
TX	PB0(uart0_rx)
RX	PB1(uart0_tx)

	LCD PINS	TM4C123 GPIO PINS
LCD Control	RS	PE1
LCD Control	RW	PE2
LCD Control	E	PE3
LCD Data	D7	PD3
LCD Data	D6	PD2
LCD Data	D5	PD1
LCD Data	D4	PD0
Power	VSS	GND
Power	VDD	VBUS
Power	VO	Potentiometer out
Power	A	VBUS
Power	K	GND

System States

The system goes through various states throughout its lifetime

• Searching state

  • The initial state of the system after it has been powered up.
  • The GPS searches for nearest satellites to read accurate locations.
  • It usually takes around 1min and it could last longer if we were in a closed place.
  • “Searching..” on the lcd and GREEN led indicate we are in the searching state.

• Waiting state

  • We enter the Waiting state after the GPS has initialized correctly and we can get readings now.
  • We should push SW1 to exits this state and start moving.
  • “GPS Ready” on the lcd indicates we are in the waiting state.

• Reading state

  • When we are moving, and the distance is being accumulated.
  • the distance we have moved would appear on lcd.
  • BLUE led indicates we are in the reading state.

• Reaching state

  • When we reach our destination, which is Total distance of 100m or more.
  • The readings shall stop, and we shall not increase the distance again.
  • RED led indicates we have reached our destination.

• Error state

  • This state is rare and should not occur in normal operation.
  • It occurs if the GPS disconnected, or it cannot find enough satellites to get reading from during the reading state.
  • “Error: GPS Stopped" on the lcd indicates we are in Error state.
  • A valid reading from the GPS would exit this state and return to Reading state.

Trajectory Plotter Andriod App

We have made an android application which connects to the TivaC through Bluetooth Module and receives a real time location updates from the TivaC and plots real time coordinates on map and draw the trajectory using Google Maps API as shown in the following GIF.

Trajectory Plotter Python Script

The python script receives a real time location updates from UART0 and store coordinates in array and after reaching our destination it plots Trajectory using gmplot package as shown in the following figure.

Trajectory plot generated by Python script on PC

Trajectoy on Google Maps