Skip to content
/ IthoMQTT Public
forked from BertrandR/IthoMQTT

Control the Itho Daalderop Eco Fan RFT using a microcontroller and CC1101 chip. The original code is fully tested using a STK500 and ATMega328P, this fork is modified for use with an Arduino or ESP8266. The following Itho commands are working: low, medium, full, 3 different timers, join and leave. The code will give you full remote control over …

Notifications You must be signed in to change notification settings

mptrs/IthoMQTT

 
 

Folders and files

NameName
Last commit message
Last commit date

Latest commit

 

History

42 Commits
 
 
 
 
 
 
 
 

Repository files navigation

IthoEcoFanRFT

Cloned from superskimmie (who cloned from klusjesman)

This sketch is made to work on Arduino and ESP8266 with Arduino IDE

Will work with a 868MHz CC1101 module. The CC1150 may also work, except for receiving (which is not required for controlling an Itho EcoFan). A 433MHz CC1101/CC1150 might also work, because it has the same chip. But a 433MHz CC11xx board has a different RF filter, causing a lot less transmission power (and reception).

Connections between the CC1101 and the ESP8266 or Arduino:
CC11xx pins    ESP pins Arduino pins  Description
*  1 - VCC        VCC      VCC           3v3
*  2 - GND        GND      GND           Ground
*  3 - MOSI       13=D7    Pin 11        Data input to CC11xx
*  4 - SCK        14=D5    Pin 13        Clock pin
*  5 - MISO/GDO1  12=D6    Pin 12        Data output from CC11xx / serial clock from CC11xx
*  6 - GDO0       ?        Pin 2?        Serial data to CC11xx
*  7 - CSN        15=D8    Pin 10        Chip select / (SPI_SS)
*  8 - GDO2       ?        Pin  ?        output as a symbol of receiving or sending data

Note that CC11xx pins GDO0 and GDO2 are not used (yet).

Beware that the CC11xx modules are 3.3V (3.6V max) on all pins! This won't be a problem with an ESP8266, but for Arduino you either need to use a 3.3V Arduino or use levelshifters and a separate 3.3V power source.

About

Control the Itho Daalderop Eco Fan RFT using a microcontroller and CC1101 chip. The original code is fully tested using a STK500 and ATMega328P, this fork is modified for use with an Arduino or ESP8266. The following Itho commands are working: low, medium, full, 3 different timers, join and leave. The code will give you full remote control over …

Resources

Stars

Watchers

Forks

Releases

No releases published

Packages

No packages published

Languages

  • C++ 100.0%