-
Gigaweb B.V.
- The Netherlands
-
21:48
(UTC +02:00) - https://www.roelbroersma.nl
- @roelbroersma
Pinned Loading
-
tunnel-gui
tunnel-gui PublicThis is a simple web-based GUI for a (Diet/Raspberry)Pi or Docker, based on OpenVPN with Multicast support. It simplifies the whole multicast/openvpn hassle for you so you can just focus on having …
-
WLED-usermodv2_HttpPullLightControl
WLED-usermodv2_HttpPullLightControl PublicForked from Aircoookie/WLED
HttpPullLightControl is a usermod_v2 to let WLED poll a URL and turn LEDs on/off/colored depending on the JSON response.
C++
-
Multipin relay support in WLED (cha...
Multipin relay support in WLED (change usermods/esp32_multistrip/NpbWrapper.h ) 1Add the following code in usermods/esp32_multistrip/NpbWrapper.h after:
2#ifndef RLYPIN
3#define RLYPIN -1 //pin for relay, will be set HIGH if LEDs are on (-1 to disable). Also usable for standby leds, triggers,...
4#endif
5 -
monitor
monitor PublicForked from andrewjfreyer/monitor
Distributed advertisement-based BTLE presence detection reported via mqtt
Shell
-
When using Synology Snapshots and re...
When using Synology Snapshots and replicating these to another local volume, those snapshots (ending with ...-1) will automatically be visible (read-only) on the network. You can set 'Hide this folder in My Network locations' but every thime after replicating, it will again show them. You can schedule the script below just after replicating, it will set the Shared Folders ending with ...-1 to Hidden. Unfortunatelly, when editing Shared Folders using DSM these settings will be overwritten and you need to run the script again. You can safely run it every hour. 1#!/bin/bash
23# Script to set 'browseable=no' for specific Samba shares ending with -1
4# Author: Roel Broersma
5# Description: This script modifies the smb.share.conf file to set 'browseable=no'
-
socat-proxy
socat-proxy PublicSocat Proxy is the ultimate Multicast proxy to proxy MDNS, KNX and other multicast protocols to another VLAN, (vpn)site or network.
Shell 1
If the problem persists, check the GitHub status page or contact support.