aquapureD

linux daemon to control Aquapure SWG without the need for a pool control panel.

Note

This is still in beta mode.

After downloading Please edit ./release/aquapured.conf and change configuration to your setup.

To run sudo ./release/aquapured -d -c ./release/aquapured.conf

Currently supported

SWG using Jandy protocol (this is most SWG, including Pentair). MQTT, Web API, Web Sockets and Basic Web UI Use of GPIO to control relays to turn on/off other pool equiptment. Homekit integration with homekit-aqualinkd

Web API

http://ip/?command=status                   (return JSON status)
http://ip/?command=swg_percent&value=50     (Set SWG Percent to 50)
http://ip/?command=swg&value=on             (Set SWG on or off)
http://ip/?command=GPIO_13&value=on         (Set GPIO 13 on or off)

MQTT status

#### Status posted.  0=off 1=on, unless otherwise stated
aquapured/SWG                (0 off, 2 on and generating salt.)
aquapured/SWG/enabled        (0 off, 2 on but not generating salt - SWG reported no-flow or equiv.)
aquapured/SWG/Percent        (SWG Generating %, i.e. 50, value between 0 and 101)
aquapured/SWG/fullstatus     (0 on, 1 no flow, 2 low salt, 4 high salt, 8 clean cell, 9 turning off, 16 high current, 32 low volts, 64 low temp, 128 check PCB, 255 off)
aquapured/SWG/PPM            ( SWG Parts Per Million i.e. 3100)
aquapured/SWG/Boost          ( Boost on or off, 1 or 0)
aquapured/GPIO_13            (GPIO 13 on or off, 1 or 0)
aquapured/GPIO_XX            (XX = any GPIO you've configured)

Make requests over MQTT

Add /set to topic and messages are 0=off, 1=on or number between 1 and 100 for percent. 
aquapured/SWG/set           (Message is 0 or 1, Not really relivent on many systems, will depend on physical Pump to SWG wiring)
aquapured/SWG/Percent/set   (Message is number between 0 and 100)
aquapured/SWG/Boost/set     (Message is 0 or 1)
aquapured/GPIO_13/set       (Message is 0 or 1)