-
-
Notifications
You must be signed in to change notification settings - Fork 70
Calibration Cube XYZ
This model allow you to print a calibration cube (The name can be a source of error. More than a calibration, it is a calibration control which is made with this model.) It's useful to see if your printer is accurate and calibrate some settings.
You have to print two cubes, with different sizes. If the dimensional inaccuracy scale with the size of the cubes, then it's the steps/mm of your steppers that needs some adjustments (note: if it's the case, you should also adjust the flow, and maybe redo some calibrations if the change is big). If it doesn't scale, you can correct it by adjusting your xy compensation (slicing tab).
This test is about to see if the pattern of the infill can be seen on the perimeters. Try to reduce it as low as you can but check the top solid fill, as it can create artifacts if it's too low.
Default size of the standard cube is 20mm.
Licence for the standard calibration cube: CC BY-SA 3.0, iDig3Dprinting https://www.thingiverse.com/thing:1278865
Calibration-Shapes Plugin On Ultimaker Marketplace