Skip to content

Prime Edition MkIII. Quick start

Linar Yusupov edited this page Nov 17, 2023 · 4 revisions
  1. Download firmware binaries into your Prime Edition Mark III. Follow these instructions. 1

    1 - this operation is typically not required when the T-Beam Supreme board comes with factory pre-installed SoftRF firmware.

  2. Move your Prime MkIII into an area of good GPS/GLONASS/BeiDou/Galileo reception, turn on and leave nearby.

  3. Connect your Tablet/Cellphone to SoftRF Wi-Fi Access Point.
    SSID: SoftRF-XXXXXX
    Key: 12345678

  4. Open up a browser then proceed to this URL: http://192.168.1.1

  5. A page like this should come up:


  1. Open up Settings menu. Select NMEA UDP option. Press Save and restart button.




  1. Disconnect from SoftRF AP and connect to internet.
    Install XCSoar app from Google Play.
    Re-connect to SoftRF AP.

  2. Open the XCSoar app in Fly mode. Double tap the screen then select Config:





  1. Select Devices:




  1. Push Edit button then configure the device as follows:






  1. Push Monitor button and see if your tablet/phone is receiving NMEA data from your Prime Edition Mark III:




  1. Return all the way back to XCSoar main screen:




  1. Swipe three times to the left to reach Radar View. When any other traffic (SoftRF or OGN Tracker) is around - you should see it on this screen:




Hardware

SoftRF

SkyView

Flight Recorder

Adapters

Software

Firmware

Tools

Protocols

Clone this wiki locally