Skip to content

WebTop USB. Quick start

Linar Yusupov edited this page Dec 23, 2022 · 1 revision
  1. Make sure that these DIP switches are configured to provide OTG function over USB 'Male' port ;


  1. Download firmware binaries into your WebTop USB. Follow these instructions ;

  2. Set position of the DIP switches as follows ;



  1. Plug an appropriate SoftRF Edition device into USB 'Female' port, then connect the T-Dongle to a power source ;


  1. Wait until completion of the boot sequence ;


  1. Move your WebTop USB into an area of good GPS/GLONASS reception ;

  2. Connect your Tablet/Cellphone to SoftRF Wi-Fi Access Point.
    SSID: SoftRF-XXXXXX
    Key: 12345678

  3. Open up a browser then proceed to this URL: http://192.168.1.1

  4. A page like this should come up:



  1. Open up the XCSoar app in Fly mode. Double tap the screen then select Config:




  1. Select Devices:




  1. Push Edit button then configure the device as follows:






  1. Push Monitor button and see if your tablet/phone is receiving NMEA data from your Prime Edition Mark II:




  1. Return all the way back to XCSoar main screen:




  1. Swipe three times to the left to reach Radar View. When any other traffic (OGN Tracker or another Prime MkII) is around - you should see it on this screen:



Hardware

SoftRF

SkyView

Flight Recorder

Adapters

Software

Firmware

Tools

Protocols

Clone this wiki locally